![]() If filter is still not priming answer the following questions:.As soon as the tone changes immediately tighten the filter.You will hear the air being released and the tone of the motor should change as the fuel loads the pump LOOSEN FUEL FILTER (not the water separator) while only the pump is running.Once the tone has changed then tighten the filter.Allow it to run 30 – 60 seconds (the tone of the motor should change once the fuel reaches the pump).Turn unit on (Dodge 24 valve may need to bump the starter more than once, so do this before the pump shuts off).With engine off, crack the fuel filter (not the water separator).Make sure material inside is a wire screen mesh (don’t use paper or cellulose) With engine off, loosen clamps on both sides of filter.Install new filters (Torque specs are in your owner’s manual).PROCEDURES FOR SERVICING THE FILTER/SEPARATOR No less than 7 psi (light will come on at 7psi) With a Fuel Pressure Gauge/Indicator Light (part # IL-1001) ![]() Losing fuel pressure/running out of fue.l High fuel pressure after installation. Pump sounds as though it’s turning on and off. Procedures for servicing your filters/separator.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |